Storage and maintenance methods for excavators hydraulic breakers hammer

As a common equipment, excavators hydraulic breakers hammer will not cause any major problems in normal use, but if it is not used for a long time, it will more or less affect its performance, especially if it is improperly stored. Therefore, it is very necessary to correctly understand the storage precautions of the crusher equipment. Here is an introduction to the long-term storage method of excavators hydraulic breakers hammer:

1. It should be parked in a dry room during storage. Those who have to park outdoors should choose a flat ground and cover with wooden boards. Cover it with a drape after parking.

2. The arrangement and arrangement of the parking area during storage should ensure that the entry and exit of any machine is not affected by other machines.

3. When storing, place the mechanical fuel control lever in the idle position and each control lever in the neutral position.

4. Before long-term storage, the machinery must be maintained, repaired damaged parts, and thoroughly cleaned up to maintain a good technical condition.

5. Before storing, disassemble the battery and place the battery in a dry and frost-proof place. Keep its surface clean and dry. It is strictly forbidden to place conductive objects on the battery.

6. Before storage, the cooling water in the engine should be drained, and the engine oil should be replaced. During the shutdown period, the engine should be started once a month to make the machine run for a short distance, so that a new oil film is established at the lubrication of each part to prevent rust. It should be noted that the cooling water should be filled before starting, and the cooling water should be drained at the end.

In addition, when the hydraulic breaker is stored, if it is in a low temperature environment, it must be lubricated with a lower viscosity grease and then stored, so that the internal parts of the excavators hydraulic breakers hammer can be well lubricated to prevent Severe friction occurs between the components, causing damage to the components.

　　With the development of society, people pay more and more attention to the use of hydraulic breakers. So what do you know about hydraulic breakers? Let's give you a detailed introduction to the relevant knowledge about the rules to be followed when the hydraulic breaker is maintained.

1. Keep the hydraulic components clean. Dirt is the main culprit leading to the failure of the hydraulic system.

2. The excavators hydraulic breakers hammer components should be stored in a clean place, cleaned with hydraulic oil before use, and can not be cleaned with water vapor, paint or acid.

3. Sealing elements, such as O-rings, gaskets, etc., should be cleaned with clean hydraulic oil before equipment, especially for some tight hydraulic components during installation, lubricating oil should be added to their sliding surfaces.

4. Before maintaining or repairing the hydraulic breaker, the gas in the rear cover and accumulator should be discharged.

5. Use the correct maintenance tools.

6. Without authorization, the hydraulic breaker shall not be altered or modified. The company does not provide warranty for the problems caused by this or the shortening of the life of the hydraulic breaker.

　　 Any equipment must be maintained during use or after use. This is not only to ensure the normal operation of the excavators hydraulic breakers hammer, but also to prepare for the prolonged service life of the hydraulic breaker.